Norski PVA Release Agent
CraftFor those that want to go to the absolute limit with their moulds, you may need to apply a layer of PVA Release Agent.
This product is really quite incredible and can only really be described as ‘paint on cling film’, applied as a liquid, this fast curing product becomes a thin film offering complete separation between your mould and your poured article.
Normally applied over 'Norski Mould Release Wax' this product is best applied with a spray bottle, however can be applied with a cloth or sponge, leave to cure (approx 1 hour) and then carry out your pour.
Click here to view the user instructions.
VIEW NOWNorski Mould Release Wax
CraftMould release wax is the answer for getting your products out of the mould, this is what the professionals use.
Based on the same principle as waxing your vehicle, however, this product is applied with a clean cloth then wiped off with another clean cloth. This process needs to be repeated up to 5 times leaving an absolutely microscopically thin layer of wax on your mould which will enable you to get the trickiest of shapes out of your mould.
Click here to view the user instructions.
Click here to download the SDS for this product
VIEW NOWNorski Industrial Syringes - 60ml
CraftThese are super handy for getting resin into places that it may not naturally go. Especially great for filling cracks in timber with resin and really good for getting a precise volume measurement if required.
VIEW NOWNorski Silica Sand
SundryOne kilogram bags of sand, supplied in either ‘fine’ or ‘coarse’ variants for adding to any substrate to create a non-skid finish.
VIEW NOWNorski 4 to 1 Epoxy Pumps (Fits 5L Pack only)
SundryThese pumps are awesome for pumping the correct volumes of our 4:1 Epoxy Resin. One pump from the large pump equals 4 x the volume of one pump of the small pump.
Please note: 4:1 is not weighed for its measure -it's 4:1 by volume (ie: you actually need to measure it)
Click here to download the user instructions.
VIEW NOW